I have a VB.NET 2003 application that I need the user to be able to
configure after installation, before running it. I am using the installer
than comes with VS.NET and have added an installer to my solution, which
works well and installs the application successfully. I have also added a
configuration project to my solution, then in the Custom Actions section of
the installer, under Install, I have added 'Primary Output from
Configuration (Active)', hoping that this would run the configuration
utility once the installation had completed. However, it doesn't - it just
installs normally, but the configuration application does not run. If I run
the configuration utility by clicking on the .EXE, it works fine. What am I
doing wrong? Thanks in advance.
Andy Baker