Hallo Nicolas ,
Although i can read , speak and understand German pretty good i will answer
you in the English language as this is the common language in this newsgroup
The problems you encounter are installer based and can have several causes
Most obvious is the fact that during the transfer of the file , to the
target system it might have got corrupted .
Try another deploy media , if you copied it over a network , try a CD-Rom
and vice versa ( bad network connection , or bad media cq hardware )
If the problem stil exists and you are sure the file is not corrupted and
100% exact as the one you use on your dev system well then it is time to do
some logging :-)
to enable verbose logging folow the steps descibed here
http://blogs.msdn.com/astebner/archi...29/403575.aspx
regards
and succes :-)
Michel Posseth [MCP]
"Nicolas Nickisch" wrote:
Hallo newsgroup,
ich habe unter VB.net ein Programm entwickelt und nach einigem Hin und her
sogar ein passendes setup Projekt hin bekommen.
VisualStudio hat also eine setup.exe und ein .msi-File erstellt.
Auf dem Quellrechner lässt sich dieses Paket auch problemlos installieren.
Im entsprechenden Verzeichnis findet man anschließend neben der
Programmdatei eine ganze Reihe von DLL-Dateien.
Nun habe ich die .msi-Datei und die setup.exe auf einen anderen Rechner
kopiert um das Programm dort ebenfalls installieren.
Bei der Installation beschwert sich der Installer, dass er aus der
..msi-Datei nicht lesen könne. Eine genauere Fehlermeldung erhalte ich nicht.
Kann sich jemand dieses Verhalten erklären? Gibt es Möglichkeiten einer
genauere Fehlermeldung zu bekommen?
Gruss Nico