Modem Communication

[muruganyuva]

Hi
In my project use mscomm control for communication between source(computer) to destination(electronic equipment).I have use two modem, one for source side and other one is destination side. In source side dial the destination side telephone number after the connection establishment data can be transfer from destination side to source side.In source side give a command to response the destination side
I have a small problem how to terminate remote side modem?

[pbmods]

Heya, muruganyuva. Welcome to TSDN!

Are you writing a program to do this? What programming language are you using to write the program?

Are you doing this using shell or batch scripts? What operating system are you designing your interface for?

[hariharanmca]

Welcome to TSDN,

hope it's here what you need for your query.




Good Luck.

[muruganyuva]

hi,

in my project i'm sending the data from source to destination with the help of modem.
one modem at the source and other at the destination.

at first i'm initializing the source modem.

"AT E0 V1 X4 N1 &D0 &K0 S0=2"

Then i connects the modem and transfer the data.

while disconnecting i change the data mode of the modem to the command mode (+++ command) and then disconnects
the modem by ATH command.

When i again connects the modem and try to send data, its not connecting properly some times.
If we switch off the destination modem and then try means its connecting properly.

how to solve this problem?
Is there any way to reset the destination modem from the source??

[muruganyuva]

hi,

in my project i'm sending the data from source to destination with the help of modem.
one modem at the source and other at the destination.

at first i'm initializing the source modem.

"AT E0 V1 X4 N1 &D0 &K0 S0=2"

Then i connects the modem and transfer the data.

while disconnecting i change the data mode of the modem to the command mode (+++ command) and then disconnects
the modem by ATH command.

When i again connects the modem and try to send data, its not connecting properly some times.
If we switch off the destination modem and then try means its connecting properly.

how to solve this problem?
Is there any way to reset the destination modem from the source??


Operating System : Windows XP
Software :Visual Basic 6.0 and Ms Access

[hariharanmca]

hi,

in my project i'm sending the data from source to destination with the help of modem.
one modem at the source and other at the destination.

at first i'm initializing the source modem.

"AT E0 V1 X4 N1 &D0 &K0 S0=2"

Then i connects the modem and transfer the data.

while disconnecting i change the data mode of the modem to the command mode (+++ command) and then disconnects
the modem by ATH command.

When i again connects the modem and try to send data, its not connecting properly some times.
If we switch off the destination modem and then try means its connecting properly.

how to solve this problem?
Is there any way to reset the destination modem from the source??


Operating System : Windows XP
Software :Visual Basic 6.0 and Ms Access

This have to move in VB forum or Networking forum.

muruganyuva, Cany post your code what you had tryed (I am not sure that problem is with code or Modem, Because once your code is executing properly then; how it go wrong for the second time? just want to check)

[pbmods]

Heya, Muruganyuva.

I'm going to go ahead and move this thread to the Networking forum, where our resident Experts will be better able to help you out.