By using this site, you agree to our updated Privacy Policy and our Terms of Use. Manage your Cookies Settings.
434,894 Members | 1,937 Online
Bytes IT Community
+ Ask a Question
Need help? Post your question and get tips & solutions from a community of 434,894 IT Pros & Developers. It's quick & easy.

SerialPort class and ExcapeCommFunction

P: n/a
During my tests with SerialPort component I discovered that setting
RtsEnable to new value causes a series of IOCTLs to the driver. I
suppose that a DCB is read, modified and set.

That is somewhat complicated and for the MS Com (serial.sys) driver
little too much: BeginWrite/EndWrite stops to work due to the driver
holding the output.

A lightweight EscapeCommFunction would server my purpose much better. Is
there a way to use it? (I used this with C++ and it works fine in
similar application).

Background: while sending data via the port I change the RTS pin. I use
a loop back connector so I can check the reaction on that change (CTS)
during heavy load. Setting the Rts (probably in this implementation DCB
with baud rate, Handflow, Chars and so on -PortMon) causes the data
sending to stop after short while. After closing port a reopen is
impossible. Only Disable/Enable port with Device Manager can make it
available again.

Any suggestion?
Damian
Oct 2 '06 #1
Share this question for a faster answer!
Share on Google+

This discussion thread is closed

Replies have been disabled for this discussion.