On 1 Jun 2005 07:25:05 -0700, "AP" <ap******@thompsongroup.com> wrote:
Is there a way to change a subform from single view to continuous view
without switching back to design view. I have used the run command in
the past to switch to datasheet view, but cant seem to get it to toggle
between regular and continuous.
Don't think so.
You can switch into design mode and out again with echo off, which
conceals what is going on, though you wil have to reset the record
pointer and possibly other things when you resume. This could be quite
complicated for a form/subform.
David